Fluke 5700A-01-03

Multi-Function Calibrator

The 5700A Calibrator is designed to cover the widest portion of today's calibration workload - a wide variety of DMMs from all manufacturers. It delivers direct voltage to 1100V and alternating voltage from 220V to 1100V at frequencies from 10Hz to 1.2MHz. Cardinal point resistances range from 1-ohm to 100 Mohms in x1 and x1.9 decades, including a short. Direct and alternating current are provided to 2.2 A, and frequencies for alternating current range from 10Hz to 10kHz.

In service since 1988, the 5700A has undergone continuous improvements to become the 5700A Series II, one of the most tested and reliable high precision calibrators Fluke has ever produced. Considered the calibration standard worldwide, the 5700A delivers high value as well as accuracy covering 5 1/2 to 7 1/2 digit dmms. Plus it offers the same ease of use, low cost of ownership, rugged design, simplified support and confidence building features as the 5720A.

Specifications for both the 5700A and 5720A are stated with a choice of confidence levels. Now, you can use the conservative 99% specifications that Fluke traditionally publishes, or more aggressive 95% specifications recommended in many international procedures. In addition to allowing you to trade a small amount of risk for better performance, 95% confidence level specifications allow easier measurement intercomparisons. Both specifications are available at a press of the SPEC key for any output.

Both the 5700A and 5720A can emulate, via the remote interface, either a 5100B or 5200A calibrator, permitting them to replace those older calibrators in automated systems with little or no impact on software. In addition, it is compatible with the 5725A Amplifier, and 5205A or 5215A Precision Power Amplifiers.

Options:
Option 5700A-01 = Rear Output
Option 5700A-03 = Wideband AC Voltage
Option 5700A-04 = Rear Output + Wideband AC Voltage

Fluke 5700A-01-03 datasheet & specifications