Quadtech Hybrid 2000 Hipot Testers
Follow us for the latest equipment specials.
New Quadtech Hybrid 2000
Call 1-800-615-8378 or 407-804-1299 for more information
Sell Equipment Repairs Add to cart E-mail this page Alert me when this goes on sale
Quadtech Hybrid 2000 Details
Quadtech Hybrid 2000
Hipot Resistance Meter
The only hipot and 4 wire resistance meter on the market. The Hybrid 2000 Analyzer is a complete dielectric testing solution with AC Hipot, DC Hipot, Insulation Resistance and DC Resistance testing capability. The Hybrid 2000 combines these four test modes with eight HV scan channels for fast multi-point testing. The Hybrid 2000 has Open/Short Circuit detection for establishing proper device connection and Load/Line regulation to ensure measurement integrity. The digital display and user friendly controls allow test parameters and limits to be set without the high voltage activated.
- Perform hipot & contact resistance testing with one instrument
- Automatic switching for multi-point testing
- Monitor resistance while checking intermittent connections
- Insulation resistance testing up to 5000V DC
- New and improved DC resistance 2 or 4 wire
- Substep function allows for secondary tests to be performed after failure
- DC resistance temperature compensation
- DCR Balance
- AC Dielectric Withstand Voltage 50 to 5000VAC, Current to 30mA
- DC Dielectric Withstand Voltage 50 to 6000VDC, Current to 10mA
- IR Measurements from 1MΩ to 50GΩ, Test Voltage 50 to 5000VDC
- DC Resistance Measurements from 50mΩ to 100kΩ
- Real and Total Current Measurement
- Built-in Scanner with 8 HV Output Channels for Multi-Point Testing
- Programmable Hi/Lo Limits for Pass/Fail Testing
- Ability to Perform Multiple Tests in Sequence
- Internal Storage and Recall of 50 Test Setups, 20 Steps Each
- Programmable Ramp, Dwell, Test and Fall Times
- Open/Short Circuit Check to Ensure the Device is Connected
- Pause Mode Allows the Operator to Change Device Connection & Continue
- Front Panel Lockout Prevents Changes to the Test Setup
- Automatic Offset to Zero Out Residual Current
- Ground Fault Interrupt (GFI) for auto shutdown if current imbalance >0.5mA
- RS232 Interface Included Standard
- Built-In Operator Prompted Software Calibration Routine
- CE Marked