Quadtech 1730T

Precision LCR Meter

The 1730T LCR Meter will measure, display, and output the results of any two parameters, including: series or parallel capacitance (C), AC or DC resistance (R or DCR), or Inductance (L), Inductance of a Coil A or B (L2), Mutual Inductance (M), Dissipation factor (D), Quality factor (Q), Equivalent Series Resistance (ESR), Impedance (Z), Reactance (X), Turns Ratio (N or 1/N), and Phase angle. For characterizing devices over a wide range, the unit provides ten programmable test frequencies from 50Hz to 100kHz. The test signal monitoring function displays the voltage across and current through the device under test, leaving no doubt of the actual test conditions.

• 10 Test Frequencies, User selectable: 50Hz, 60Hz, 100Hz, 120Hz, 1kHz, 10kHz, 20kHz, 40kHz, 50kHz and 100kHz.
• 14 Measurement Parameters: Measure and display two of 14 impedance parameters simultaneously with a basic accuracy of 0.1 percent. Test results can also be shown as Deviation or %Deviation from nominal value.
• LCD Display: Large, high resolution graphic display for clear, concise results and user friendly menu interface for easy programming.

• Measures 14 Impedance Parameters (2 simultaneously)
• 0.1 percent Basic Measurement Accuracy
• 10 Test Frequencies from 50Hz to 100kHz
• AC Test Voltage Programmable from 10mV to 1V
• Fast Measurement Speeds up to 62/Second Automatic
• Open/Short Zeroing Eliminates Connection Errors
• LCD Display for Menu Programming and Test Results
• Hi/Lo Comparator Limits and 8 Sorting Bins for Pass Fail Testing
• IEEE-488 and PLC Interfaces Standard
• Results Displayed as Deviation or percent Deviation from a Nominal Value
• Storage and Recall of 50 Test Setups
• Monitor Voltage and Current to the Device Under Test
• Keypad Lockout Prevents Changes to the Test Setup
• Programmable Average and Delay Times
• Capable of Applying a DC Bias Voltage or Current to the Device
• Automatic Correction for Different Test Lead Lengths

  
  
  
  
  Quadtech 1730T datasheet & specifications