Com Power SA-510 Details

Com Power SA-510

COMPOWER SA510 Spectrum Analyzer 0.15 - 1050MHz

The SA-510 Spectrum Analyzer is extremely valuable for locating EMI noise sources on systems in order to meet various regulatory agency requirements. Its frequency accuracy and affordable price allows design engineers to use it to perform preliminary EMI radiated emissions testing as well as to find the noisy signals. The SA-510/511 can also be used to isolate the noise source to a pin or trace on a PCB using a Near Field Probe set.

Frequency range: 150 kHz to 1050 MHz (-3dB)

Input impedance: 50 Ohm

Input connector: BNC

Trace rotation: Adjustable on front panel

Line voltage: 115/230V +/-10%, 50/60 Hz

Amplitude range: -100 dBm to + l3 dBm

Average noise level: -99 dBm (20 kHz BW)

Measures low amplitude signals down to -100 dBm (7 dBuV)

Measurement range of over 110 dB

Four 10 dB attenuators which can be individually turned on

Using these switchable attenuators, a range of -100 dBm to +13 dBm can be measured with 80 dB being displayed on the screen at 10 dB/ division

In "Zero Scan Mode", selective fixed frequency amplitude level measurements can be performed

4 1/2 digit numeric LED readout that can display selectively the Center Frequency or the marker frequency

Marker frequency is displayed only when the marker is turned on

Frequency measurement is accomplished by adjusting a needle like marker to the point of interest on the display and reading the 4 1/2 digit Marker Frequency value