Quadtech Hybrid 2000

QuadTech Hybrid 2000

• Perform hipot & contact resistance testing with one instrument
• Automatic switching for multi-point testing
• Monitor resistance while checking intermittent connections
• Insulation resistance testing up to 5000V DC

Features

• AC Dielectric Withstand Voltage 50 to 5000VAC, Current to 30mA
• DC Dielectric Withstand Voltage 50 to 6000VDC, Current to 10mA
• IR Measurements from 1MΩ to 50GΩ, Test Voltage 50 to 5000VDC
• DC Resistance Measurements from 50mΩ to 100kΩ
• Real and Total Current Measurement
• Built-in Scanner with 8 HV Output Channels for Multi-Point Testing
• Programmable Hi/Lo Limits for Pass/Fail Testing
• Ability to Perform Multiple Tests in Sequence
• Internal Storage and Recall of 50 Test Setups, 20 Steps Each
• Programmable Ramp, Dwell, Test and Fall Times
• Open/Short Circuit Check to Ensure the Device is Connected
• Pause Mode Allows the Operator to Change Device Connection & Continue
• Front Panel Lockout Prevents Changes to the Test Setup
• Automatic Offset to Zero Out Residual Current
• Ground Fault Interrupt (GFI) for auto shutdown if current imbalance >0.5mA
• Fast Cutoff and Quick Discharge of Device Under Test
• RS232 Interface Included Standard
• Front Panel Output Connection
• Built-In Operator Prompted Software Calibration Routine

Quadtech Hybrid 2000 datasheet & specifications