Refurbished Amplifier Research 100A250A
Request Information
Refurbished
| 100 Watt CW 10 kHz - 250 MHz Amplifier The Model 100A250A amplifier is a self-contained, broadband unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required. Utilization of push-pull MOSFET circuitry lowers distortion, improves stability and allows operation into any load impedance without damage. The Model 100A250A, when used with an RF sweep generator, will provide a minimum of 100 watts of swept power. There is a digital display on the front panel to indicate the operate status and fault conditions when an over temperature, power supply, or amplifier fault has occurred. The unit can be returned to operate when the condition has been cleared. The 100A250A includes digital control for both local and remote control of the amplifier. This 8-bit RISC microprocessor controlled board provides both IEEE-488 (GPIB) and asynchronous, full duplex RS-232 control of all amplifier functions. Housed in a stylish, contemporary enclosure (except M2, M3, M4), the Model 100A250A provides readily available RF Power for typical applications such as RF susceptibility testing, antenna and component testing, watt meter calibration, and use as a driver for higher power amplifiers. |
Amplifier Research 100A250A datasheet & specifications
