Refurbished Sorensen DCS80-13E-M9C
Request Information
Refurbished
| 80V, 13A, 1000W Programmable DC Power Supply with IEEE-488/RS232C Interface option Features: Output voltage ranges from 8-600 VDC with currents from 1.7-125A Two independent front-panel 3 .5 digit voltage/current meters Voltage and current can be set from individual 10-turn potentiometer knobs Designed for very low noise and excellent transient response Preview mode allows viewing of programmed voltage/current/overvoltage values Side cooling air inlets/exhausts allow stacking of multiple supplies Remote sense leads are easily connected to a rear panel connector Low profile 1U (1.75") high, full-rack (17") wide form factor Remote control via analog voltage or IEEE-488.2 The DCS Family of 1 kW, 1.2 kW and 3 kW programmable power supplies utilize switch-mode technology to achieve high power density in a low profile chassis. Utilizing unique packaging techniques, the DCS Family provides continuous full output power (1 kW, 1.2 kW or 3 kW) in any volt/amp combination within the rated output voltage and current limits. This family has 10-turn potentiometers to adjust voltage and current settings that are displayed simultaneously. LEDs indicate overtemperature, remote programming, shutdown and overvoltage protection, status and constant-voltage/current mode operation. The DCS 3 kW Models have push button control of the output standby mode, OVP reset, remote/local programming and preview status of voltage, current and OVP setpoints. Options: M1: Factory configured for 115 VAC input (1 kW and 1.2 kW units only) M9C: Internal IEEE-488/RS 232 Interface (May not be combined with M51A or M85) M13: Locking shafts (front panel potentiometers) M32: Master/slave paralleling cable configured for two or more units M33: Replace input connector with terminal block (3 kW only) M47: Provides a fixed 28.5 VDC outpout and no front panel meters M51: Isolated Analog Programming M51A: Isolated analog programming control of V/I/OVP and isolated V/I monitor and status outputs up to 500V relative to the supply’s return line (May not be combined with M9C or M85) M85: Multichannel slave interface allows use of a single GPIB address (using 1 master unit with M9C option) to control multiple units via a standard RS485 connector (3 ft. connector included) (May not be combined with M9C or M51A) Features: -Metered -Regulation: 0.1% -Programmable -DCS units designated with an "E" are certified to meet the 1997 Low Voltage and Electromagnetic Compatibility Directive Requirements of the European Community. |
Sorensen DCS80-13E-M9C datasheet & specifications
