Text For Info, USA Phones only


Refurbished Com-Power SA-510


Com-Power SA-510

Request Information
Refurbished
COMPOWER SA510 Spectrum Analyzer 0.15 - 1050MHz

The SA-510 Spectrum Analyzer is extremely valuable for locating EMI noise sources on systems in order to meet various regulatory agency requirements. Its frequency accuracy and affordable price allows design engineers to use it to perform preliminary EMI radiated emissions testing as well as to find the noisy signals. The SA-510/511 can also be used to isolate the noise source to a pin or trace on a PCB using a Near Field Probe set.

  • Frequency range: 150 kHz to 1050 MHz (-3dB)
  • Input impedance: 50 Ohm
  • Input connector: BNC
  • Trace rotation: Adjustable on front panel
  • Line voltage: 115/230V +/-10%, 50/60 Hz
  • Amplitude range: -100 dBm to + l3 dBm
  • Average noise level: -99 dBm (20 kHz BW)
  • Measures low amplitude signals down to -100 dBm (7 dBuV)
  • Measurement range of over 110 dB
  • Four 10 dB attenuators which can be individually turned on
  • Using these switchable attenuators, a range of -100 dBm to +13 dBm can be measured with 80 dB being displayed on the screen at 10 dB/ division
  • In "Zero Scan Mode", selective fixed frequency amplitude level measurements can be performed
  • 4 1/2 digit numeric LED readout that can display selectively the Center Frequency or the marker frequency
  • Marker frequency is displayed only when the marker is turned on
  • Frequency measurement is accomplished by adjusting a needle like marker to the point of interest on the display and reading the 4 1/2 digit Marker Frequency value

    Com-Power SA-510 datasheet & specifications

    REQUEST QUOTE
     
    What product are you interested in?
     *
    Your Name
    *
    Your Company
    *
    Email
    *
    Verify Email
    *
    Telephone
    Fax
    Country
    *
    State
    Address
    City
    Zipcode
    Referral
    Additional Comments