New Cisco WS-X6708-10G-3C
Request Information
New
| Cisco WS-X6708-10G-3C 6500 8-Port 10 Gigabit Ethernet Module with DFC3C, requires X2 The 8-port 10 Gigabit Ethernet module is supported in the Catalyst 6500 Series chassis as well as Cisco 7600 Series Routers. When operating in an E-Series chassis (6503-E, 6504-E, 6506-E, 6509-E), the 6509-NEB-A chassis with dual fan tray, or 7604 chassis or 7609 chassis with dual fan tray, the configuration is NEBS 3 compliant (supports operating temperatures up to 55 degrees C). When operating in a non-E-Series chassis (6506, 6509, 6513) or 6509-NEB-A with single fan tray, 7606/7613 chassis, or 7609 with single fan tray, fan tray 2 and 2500W or higher power supplies are required, and the configuration is not NEBS 3 compliant (supports operating temperatures up to 40 degrees C only). The module can be deployed in all slots of a 3/4/6/9-slot chassis. When operating in a 13-slot chassis, it must be deployed in slots 9-13. It is not supported in the 6503 non-E Series chassis. The 8-port 10 Gigabit Ethernet module is interoperable with all models of the Cisco Catalyst 6500 Series Supervisor Engine 720, including WS-Sup720, WS-Sup720-3B, and WS-Sup720-3BXL. When mixing DFCs in the same chassis, the chassis will operate in the mode of the lowest common denominator. The following optics will be supported on the 8-port 10 Gigabit Ethernet module at FCS: X2-10GB-SR, X2-10GB-LR, X2-10GB-ER, X2-10GB-LX4, X2-10GB-CX4. Only the -02 version or later of these optics will be supported on this 8-port 10 Gigabit Ethernet module. The -01 version of the optics is not supported. The SR optics provide 26m over FDDI-grade multimode fiber and are ideal for deployment in data center for server aggregation. The LX4 optics provide 300m over multimode fiber and are ideal for deployment in campus LAN uplinks. |
Cisco WS-X6708-10G-3C datasheet & specifications
