Sorensen DCS60-50-M12

Programmable Power Supply 0-60V, 0-50A

The Sorensen DCS60-50, 3 kW DC Programmable Switching Power Supply incorporates current mode switching rates up to 100 kHz in high power density, low profile chassis. Utilizing unique packaging techniques, the DCS60-50 provides full output power (3 kW) in any volt/amp combination within the rated output voltage and current limits.

The DCS60-50 has 10 turn potentiometers to adjust voltage and current settings that are displayed simultaneously. LEDs inindicate overtemperature, remote programing, shutdown and overvoltage protection, status and constant-voltage/current mode operation.

The DCS Family of 1 kW, 1.2 kW and 3 kW programmable power supplies utilize switch-mode technology to achieve high power density in a low profile chassis. Utilizing unique packaging techniques, the DCS Family provides continuous full output power (1 kW, 1.2 kW or 3 kW) in any volt/amp combination within the rated output voltage and current limits.

This family has 10-turn potentiometers to adjust voltage and current settings that are displayed simultaneously. LEDs indicate overtemperature, remote programming, shutdown and overvoltage protection, status and constant-voltage/current mode operation.

The DCS 3 kW Models have push button control of the output standby mode, OVP reset, remote/local programming and preview status of voltage, current and OVP setpoints.

Options:
M1: Factory configured for 115 VAC input (1 kW and 1.2 kW units only)
M9C: Internal IEEE-488/RS 232 Interface (May not be combined with M51A or M85)
M13: Locking shafts (front panel potentiometers)
M32: Master/slave paralleling cable configured for two or more units
M33: Replace input connector with terminal block (3 kW only)
M47: Provides a fixed 28.5 VDC outpout and no front panel meters
M51: Isolated Analog Programming
M51A: Isolated analog programming control of V/I/OVP and isolated V/I monitor and status outputs up to 500V relative to the supply’s return line (May not be combined with M9C or M85)
M85: Multichannel slave interface allows use of a single GPIB address (using 1 master unit with M9C option) to control multiple units via a standard RS485 connector (3 ft. connector included) (May not be combined with M9C or M51A)

Features:
-Metered
-Regulation: 0.1%
-Programmable
-DCS units designated with an "E" are certified to meet the 1997 Low Voltage and Electromagnetic Compatibility Directive Requirements of the European Community.

Sorensen DCS60-50-M12 datasheet & specifications